Vickers VC-10 Panel
-------------------

Installation
------------
Copy the gauge file 'ArmSpoiler1.gau' into your 'FS2002\Gauges folder'

You will need to have the gauge file from the FS2000 Concorde 'Concorde.gau'.
If this file is not in your 'FS2002\Gauges' folder, the panel will not work.

Beware of the Pitch trim control. It is now from the 737 & works the opposite way round to the Concorde gauge, that used to be on the panel.

This panel now uses the radio stack from the 737, because the Concorde stack has some faults in FS2002.
To allow the use of the main panel NAV1 & NAV2 gauges, standby mode should be disabled for NAV1 & NAV2.
The Radio settings are held in the Aircraft.cfg file.
I would suggest the [Radio] section should be configured like this :-

[Radios]
// Radio Type=availiable, standby frequency, has glide slope
Audio.1=1
Com.1=1, 1
Com.2=1, 1
Nav.1=1, 0, 1
Nav.2=1, 0, 0
Adf.1=1
Transponder.1=1
Marker.1=1

---------------------------------------------------------------

Panel credits
-------------
Panel arranged by David Maltby, using the excellent 'CfgEdit' by Ed Struzynski.

I did no work on any of the gauges contained in this panel.
All gauges used are default Microsoft gauges that come with FS2000 except the Auto-arm/Auto-deploy Spoilers gauge 'ArmSpoiler1.gau' by Dragonflight Design 1999.

The 'comet.bmp' cockpit picture is based on an original photograph by Thomas Spies.
Any other bitmaps are copied from default Microsoft Aircraft.